COTTONTAIL
RABBITS are one of the most commonly observed game animals. The upper body of
light brown contrasts with the white belly fur. Long ears and stubby powder-puff
tail are distinguishing characteristics. They produce three to four litters
of young annually, beginning in late winter and continuing into early fall.
Females build a nest the size of a softball, line it with belly fur and suckle
the young for two to three weeks, at the end of which time they leave the nest.
Rabbits prefer brushy cover interspersed with open areas. Brushy fence rows,
woody stream banks and woodland borders offer good protective cover while adjacent
herbaceous plants offer succulent summer foods. In winter when food is limited,
rabbits clip twigs and gnaw the bark of woody plants. Landscaped yards provide
excellent rabbit habitat, and this accounts for the prevalence of cottontails
in most suburban and urban areas.
Control
Mechanical methods
Rabbit-proof fences offer practical and inexpensive protection for small areas of high value plants. You can exclude rabbits from vegetable and flower gardens, nurseries and ornamental plants with an 18 to 24 inch high fence of 1-inch mesh galvanized wire. Temporary posts are satisfactory. The bottom edge of wire must be carefully staked to the ground, or buried several inches, to prevent rabbits from burrowing under the fence. Well maintained fences offer assurance that rabbits will be excluded during the period the plants require protection. Tree trunk guards are effective in preventing rabbit damage to individual trees and shrubs. Cylinders of 1/4-inch mesh hardware cloth 18 to 24 inches high, set into the ground surrounding the trunk, will help prevent gnawing damage to the main stem. Multi-stemmed shrubs should be encircled with hardware cloth or 1-inch mesh wire. Commercial tree wraps and plastic guards are available from garden and horticultural supply stores, he wire cylinders and tree wraps will prevent gnawing damage from both rabbits and meadow mice. Guards and wraps are not effective when snow depth is greater than the height of the wire or wrap.
Shooting
Shooting may be used where local laws permit the discharge of firearms. Hunting can be a useful method for landowners to control rabbit numbers.
Trapping
Live trapping may be of some help in removing individual animals causing damage, however, the effectiveness of summer trapping is limited because of the number of young rabbits produced and the difficulty of baiting rabbits into traps when alternative foods are abundant. Winter live trapping, especially during periods of snow, may be more effective because food is limited. Areas showing constant rabbit activity such as tracks or gnawing on woody plants are logical places to set live traps. Metal live traps are available from some farm and garden supply stores. Wood box traps can be constructed easily. Apples are suitable baits.
Pesticides
Rabbit
repellents are usually a less-than-satisfactory method of protecting plants
from rabbit damage. Legal pesticide limitations prevent the use of most repellents
on gardens and crops. Restrictions on the labels of nearly all rabbit repellents
limit their use primarily to woody plants during in the winter season when rabbits
are likely to gnaw bark and clip twigs. Winter rains and snows erode and dilute
the repellents applied to dormant woody plants. Such woody plants as ornamental
trees and shrubs, orchard fruit trees and nursery stock can be protected effectively
by fencing, tree guards, or wraps. These mechanical methods ensure protection
with less cost, time and trouble than repellents. If repellents are used, they
must be applied as directed on the label, with particular attention to dilution,
application rates and repeat treatments.
Rabbit Live-Trap
Construction
To be effective, the rabbit trap should be constructed of fairly good lumber. The door and its guides are critical points, since gravity must close the door after the trigger is tripped. Be sure there is enough space between the guides that the door slides without binding. Some people extend the guides about 1 inch above the top of the trap to support the door, When the door is raised and the trigger is set, at least 2 inches or more of the door should be in the guide tracks. The opening should be at least 4 inches high. This height can be adjusted by changing the length of the string between the door and lever. The trigger is not complicated, although it may require some fine-tuning to ensure a quick release when contact is made.
Location and Operation
Rabbits live in areas where good escape cover is available in brush piles,
briar patches and thick fence rows. They also prefer low-cut bluegrass mixed
with clovers and shrubs. In order to catch rabbits, the box trap must be placed
in or along the runs or trails made by rabbits using these areas.
Opinions vary as to the importance of baits for the box trap. Some prefer baits such as apples, carrots or corn, while others use no bait at all. Baits may attract opossums and skunks in search of an easy meal.
Care should be taken to place the trigger notch on the edge of the hole nearest the door. This will ensure its release when the animal pushes against it upon entering the trap.
Comment
With a little modification in the size during construction, this trap design may be adapted to catch other, larger or even smaller animals. Nuisance animals may be trapped and moved to another area, using the box for transport
Caution
These traps must be used in accordance with all rules and regulations of the Wildlife Code of Missouri. Certain permits and landowner permission must be obtained before any trapping is done. When in use, the law requires that the traps be checked daily and removed when no longer in use.
Missouri Department of Conservation, University of Missouri, U.S. Fish & Wildlife Service
Content revision: 20030627
